Jan 11
16
Ok, I know how to build the shed floor using dek blocks with plywood for the floor. However, the next steps I have no clue! It will most likely by a 7′ by 7′ by 7′ shed. What type of wood do I make the walls with? plywood? Also, do I attached the side walls directly to the side of the floor joists or to the top of the floor base? How far apart do I make the studs? when making the roof, how do I make it extend over the side walls? do they sell roof shingles with explanations on how to install? any help would be appreciated. Also, if anyone knows of any free sites that offer free deck plans, that would help also.
You make the walls out of studs with a top and bottom plate. Make them on the ground then put them in place
the walls on the outside will be that exterior Texture 111 plywood they sell at homedepot in 4×8 sheets( it looks like paneling)
your walls should be on top of the plywood floor. 16" from center of each 2×4 would be your spacing for the studs. the top row of your 2×4 walls should inter-lock so you can nail one wall to the other at the top. When you make your roof frame, what ever you make it out of, have that extend as far over the sides as you wish.
any more questions go to diy.com
References :
You make the walls out of studs with a top and bottom plate. Make them on the ground then put them in place
the walls on the outside will be that exterior Texture 111 plywood they sell at homedepot in 4×8 sheets( it looks like paneling)
References :
I could sit here telling you all of the measurements but I will not you can do some leg work. Your local hardware store Lowe’s Home depot or others sell shed take a ride carry a measuring tape, book and a pencil with you draw measure and get some ideas of what you want.
References :